Sfp Module Removal - RuggedCom RuggedSwitch RSG2100P Installation Manual

Modular power over ethernet managed ethernet switch

Table of Contents

5.2.2.2 GBIC Module Removal

GBIC Modules have two locking latches on either side of the module shown in Figure 25. To

remove GBIC module, disconnect any cable and replace with dust cover to protect the optics.

User should depress both latches simultaneously and gently pull the module from the chassis. The

module should be immediately stored in an ESD-safe environment.

Figure 25: Locking latch location on GBIC optical modules

5.2.2.3 SFP Module Removal

SFP Modules are removed using the metal bail latch located on the top of the module shown in

Figure 26. To remove the SFP module, disconnect any cable and replace with dust cover to

protect the optics. User should grasp bail latch and gently pull outwards to unlock and remove the

SFP module. Removal of the SFP module is shown further in Figure 27. The module should be

immediately stored in an ESD-safe environment.

Figure 27: SFP Removal

Figure 26: SFP Bail Latch location

Rev105

Table of Contents