Table of Contents
Advertisement
Chapter 9 Routing
Table 34 Policy Route: Add/Edit (Sheet 2 of 2)
LABEL
Source Subnet
Mask
Source MAC
Address
Protocol
Source
Interface Name
Source Port
Number
WAN Interface
Apply
Cancel
9.5 RIP
Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.
9.5.1 The RIP Screen
Click Network Setting > Routing > RIP to open the RIP screen.
Figure 55 RIP
The following table describes the labels in this screen.
Table 35 RIP
LABEL
#
Interface
Version
Operation
136
DESCRIPTION
Enter the source subnet mask address.
Enter the source MAC address.
Select the transport layer protocol (TCP or UDP).
Type the source interace to which this policy route is applied.
Enter the source port number.
Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
This is the index of the interface in which the RIP setting is used.
This is the name of the interface in which the RIP setting is used.
The RIP version controls the format and the broadcasting method of the RIP
packets that the VMG sends (it recognizes both formats when receiving). RIP
version 1 is universally supported but RIP version 2 carries more information. RIP
version 1 is probably adequate for most networks, unless you have an unusual
network topology.
Select Passive to have the VMG update the routing table based on the RIP
packets received from neighbors but not advertise its route information to other
routers in this interface.
Select Active to have the VMG advertise its route information and also listen for
routing updates from neighboring routers.
VMG5313-B10A/-B30A Series User's Guide
Advertisement
Table of Contents
