Table of Contents
Advertisement
6.2 The Broadband Screen
Use this screen to change your VMG's Internet access settings. Click Network Setting >
Broadband from the menu. The summary table shows you the configured WAN services
(connections) on the VMG.
Figure 18 Network Setting > Broadband
The following table describes the labels in this screen.
Table 7 Network Setting > Broadband
LABEL
Add New WAN
Interface
#
Name
Type
Mode
Service and
Encapsulation
802.1p
802.1q
IGMP Proxy
NAT
Default
Gateway
IPv6
MLD Proxy
Modify
VMG5313-B10A/-B30A Series User's Guide
DESCRIPTION
Click this button to create a new connection.
This is the index number of the entry.
This is the service name of the connection.
This shows whether it is an ATM, Ethernet or a PTM connection.
This shows whether the connection is in routing or bridge mode.
This is the method of encapsulation used by this connection.
This indicates the 802.1p priority level assigned to traffic sent through this connection. This
displays N/A when there is no priority level assigned.
This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
This shows whether the VMG act as an IGMP proxy on this connection.
This shows whether NAT is activated or not for this connection.
This shows whether the VMG use the WAN interface of this connection as the system default
gateway.
This shows whether IPv6 is activated or not for this connection. IPv6 is not available when
the connection uses the bridging service.
This shows whether Multicast Listener Discovery (MLD) is activated or not for this
connection. MLD is not available when the connection uses the bridging service.
Click the Edit icon to configure the WAN connection.
Click the Delete icon to remove the WAN connection.
Chapter 6 Broadband
71
Advertisement
Table of Contents
