Event Logging Configuration - Intel AP440FX Technical Product Specification

AP440FX Motherboard Technical Product Specification
3.14.10.5 IRQ 3, 4, 5, 7, 9, 10, 11, 12, 14, 15
Sets the status of the IRQ. The options are:
•
Available (default)
•
Used By ISA Card
The PCI auto-configuration code looks here to see if these interrupts are available for use by a PCI
or Plug and Play device.
If an interrupt is available, the PCI auto-configuration code or the PnP configuration agent can
assign the interrupt to be used by the PCI or PnP device.
If your computer contains a legacy ISA agent that uses one of these interrupts, select Used By ISA
Card for that interrupt. This lets PCI and PnP cards know that the marked interrupts are not
available for their use.
NOTE
IRQ 3, 4, 5, and 7 may not be available in this option, depending on the setting chosen for the
COM1, COM2 and parallel ports in the Peripheral Configuration Subscreen. IRQ 14 and 15 may
not be available if the Primary and Secondary IDE ports are enabled.

3.14.11 Event Logging Configuration

This section describes the options available in the Event Logging Configuration subscreen.
3.14.11.1 Event Log Capacity
This information field tells whether the log is full.
3.14.11.2 Event Count Granularity
Defines the number of log events that must occur before the event log is updated. The default is 10
events.
3.14.11.3 Event Time Granularity (Minutes)
Defines the amount of time that must pass before the event log is updated. The default is 30
minutes.
3.14.11.4 Event Log Control
Allows users to enable or disable event logging. The options are:
•
All Events Enabled (default)
•
ECC Events Disabled
•
All Events Disabled
66