Procedure 4 - Delete User Access Codes - Kaba E-Plex 5000 Operation Manual

4. Enter UUUUUUUU#, representing a User Access Code of
between 4 and 8 numbers depending on the length of Access
Code that you selected in Procedure 1 on page 7. For example,
if your code length is 8 digits, it could be 00002240#.
5. Enter the code 00002240# again.
6. Now enter the number of hours, programmable between 01 and
24, for example 04. If you enter a Service Access Code of 00,
you can only enter the door once. If the door shuts upon exiting,
you will not be able to re-enter. This type of access is called a
one-shot code.
7. Example of Complete Entry: 102#025#00002240#00002240#04#.
8. Enter another # to indicate the end of programming.
9. The Service User Access Code 00002240 will now work in that
door, with all the access privileges assigned to a Service User
for a period of 4 hours from the time the Service User enters
his Access Code.

Procedure 4 - Delete User Access Codes

User Access Codes should be deleted if no longer needed. This frees
the numbers to be assigned to another user. Codes that may be needed
some time in the future should be de-activated rather than deleted.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 200# to delete a User Access Code.
3. Enter the ID location NNN#, where NNN is the specific User
ID location.
4. Example of complete entry: 200 #023#.
5. Enter another # to indicate the end of programming.
By deleting a User ID location, you have now also deleted a User Access
Code, allowing you to assign that number to another user if you wish.
17