Unit-To-Switch If Interface Connection - Comtech EF Data CRS-170A Installation And Operation Manual

CRS-170A L-Band 1:1 Redundancy Switch
Cables and Connections
4.3.3

Unit-to-Switch IF Interface Connection

EXAMPLE:
similarly, the Tx IF from 'Unit B' connects to the Tx IF port 'J6 Tx B' on the CRS‐170A.
The same logic applies for the Rx IF connections. It is important to note that failure to observe
this requirement will result in system malfunction.
CEFD Part No.
CA/RF10453-4
Figure 4-17. CDM-840 Unit-to-Switch L-Band IF Connections
The Tx IF from ' Unit A' connects to the Tx IF port 'J5 Tx A' on the CRS‐170A;
Qty Description
4 RoHS-Compliant Cable – IF (Tx/Rx), 50Ω Type 'N', 4'
4–19
Revision 9
MN/CRS170A.IOM