Dell Power Supply C8000 Owner's Manual page 73

6 In the Remote Access Configuration screen, verify the following settings:
• Remote Access: Enabled
• Serial port number: COM2
• Serial Port Mode: 115200 8, n, 1
• Flow Control: None
• Redirection After BIOS POST: Always
• Terminal Type: ANSI
See "Remote Access Configuration" on page 113 for details. Make sure the
last four options syncs with the host and client.
7 In the Server screen, select BMC LAN Configuration and press <Enter>.
8 In the BMC LAN Configuration screen, verify the following settings:
• BMC LAN Port Configuration: Shared-NIC
• BMC NIC IP Source: DHCP or Static (Use DHCP if your network
servers are using automatic assignment of IP addresses)
• IP Address: 192.168.001.003
• Subnet Mask: 255.255.255.000
• Gateway Address: 000.000.000.000
See "Set BMC LAN Configuration" on page 111 for details. Make sure the
host and client are on the same network
9 Press <Esc> to return to the System Setup screen. Press <Esc> again,
and a message prompts you to save the changes.
Serial Port Connection List
Signal Type Setup Option
Remote
Access
Serial Console Enabled
Redirection
Enabled
BMC Serial Enabled
Over LAN
Enabled
Serial Port Serial Port
Number Address
COM1 3F8h/2F8h
COM1 2F8h/3F8h
COM2 as SOL 3F8h/2F8h
COM2 as SOL 2F8h/3F8h
Using the System Setup Program
OS Output
Setting
ttyS0 Serial Port
ttyS1
ttyS1 Management
Port
ttyS0
73