Dell Power Supply C8000 Owner's Manual page 127

Table 2-1. D4 Token Table
Token Setup Option
0224 Embedded Video
Controller
0225 Embedded Video
Controller
022D Boot Mode
022E Boot Mode
0231 Active Processor
Cores
0232 Active Processor
Cores
0233 Active Processor
Cores
024B C States
024C C States
024D Pause on Errors
024E Pause on Errors
024F Quiet Boot
0250 Quiet Boot
0251 N/A
0252 N/A
0254 3F8h/2F8h
(continued)
Description
Enables the onboard video controller as the primary
video device.
Disables the onboard video controller.
Enables booting to Unified Extensible Firmware
Interface (UEFI) capable operating systems.
Enables booting to legacy mode, ensures compatibility
with operating systems that do not support UEFI.
Four cores of the processor are enabled This applies to
Quad-core processors only.
Two cores of the processor are enabled. This applies to
Quad-core and Dual-core processors.
Single core of the processor is enabled. This applies to
Quad-core and Dual-Core processors.
When enabled, the processor can operate in all
available Power C States. (default)
When disabled, there are no C states available for the
processor.
Enables the BIOS from prompting for F1/F2 on error.
BIOS pauses at F1/F2 prompt.
Disables the BIOS from prompting for F1/F2 on error.
BIOS pauses at F1/F2 prompt.
Enables the display of the splash or summary screen,
rather than the detail of the POST flow.
Disables the display of the splash or summary screen.
The user is able to see the detail of the POST
messages.
The NIC1 is used for PXE boot, followed by NIC2.
The NIC2 is used for PXE boot, followed by NIC1.
Sets the back serial port address to 0x3F8 and internal
serial port address to 0x2F8
Using the System Setup Program
127