Cart & Barbecue Assembly - Barbeques Galore Y0662LP Owner's Manual

Figure 6 Natural Gas models only
OUT
IN
CSA Approved
Natural Gas
Regulator
IMPORTANT :
Regulator must be
on the Barbecue
or your warranty
is void.
Access must be provided
to Shut-off Valve
Air Vents
Cart & Barbecue Assembly
1. Unpack Cart.
2. Unpack Barbecue.
3. Position barbecue on top of Cart.
4. Remove Left & Right Side Panels on both sides of cart
as shown in Figure 8.
5. With the help of your assistant, position barbecue on top
of Cart and align mounting holes as shown in Figure 9.
6. Secure with two Mushroom Head bolts and nuts at both
front sides. Do not tighten until all fasteners are in place.
3/8 FF x 1/2 MP for Y0665
1/2 FF x 1/2 MP for Y0662 &
Y0663
(refer to Pg. 13)
Yellow Teflon Pipe Thread
Sealant is recommended
for use on all pipe thread
connections
flared threads.
Stainless
Flexline
Close Nipple
Shut-off Valve
1/2-1/2" NPT
Louvers on BBQ must
remain unobstructed to
allow for combustion air.
Natural Gas
Installation
(requires an assistant)
3/8 FF x 3/8 MF
use on Y0665, Y0662 & Y0663
Propane models
refer to Page 13
EXCEPT
7. Secure with Washer Head bolts (no nuts required) as
follows:
Y0662 (52" BBQ)
Natural
Y0663 (38" BBQ)
Gas
Y0665 (27" BBQ)
Supply
You may need your assistant to adjust the position of the
barbecue so that the holes are all aligned.
8. Once barbecue & cart are aligned, tighten all bolts.
9. Replace Left & Right Side Panels.
Side Panel
Figure 7
Nuts at
front only
(2)
- 7 -
Cart model LP Gas
Connection
CSA Approved
Rubber Gas Hose
6 bolts at rear & side
5 bolts at rear & side
4 bolts at rear & side
Nutserts
Bolts
Figure 8
Bolts
Washer
Head
Bolts
Figure 9