Assembly Instructions; Electrode Check - Requires An Assistant; Lnstalling Cooking Components - Barbeques Galore Y0662LP Owner's Manual

Assembly Instructions

1. Unscrew Igniter Cap(s) located on the grill Control
Panel and remove the Contact(s) and Spring(s) from
the Battery Holder(s).
2. Place an "AA" battery into Battery Holder(s). Be sure
to place the positive pole facing toward you. See
Figure 13.
Figure 13
BATTERY HOLDER
CONTACT
IGNITER
CAP
CONTACT SPRING
3. Place the Spring over the AA battery, then place the
Contact on top of the Spring. Screw Igniter Cap(s)
back onto the grill Control Panel.

Electrode Check - Requires an Assistant

Before placing the cooking components into your grill,
ensure that the Spark Electrode Tips are properly positioned
within each Gas Collector Box (a 3-1/4" wide stainless mech-
anism found at the front between each set of burners.) The
easiest way to ensure this is to perform this Electrode Check:
1. Be sure all Control Knobs are set to "OFF". Open the Grill
Lid.
2. Have an assistant stand behind to the right of the grill and
look down at the Gas Collector Box of the main burners.
NEVER put your face inside Grill Head.
3. Press center Igniter Cap and have assistant watch for a
small blue spark within each Gas Collector Box. if a spark
is present the Electrode Tips are properly positioned.
Figure 14 GAS COLLECTOR BOX
3/16"
SPARK
SPARK ELECTRODE TIP
GAP
4. If no spark is seen, the Spark Gap shown in Figure 14
needs to be adjusted as follows:
Using an adjustable wrench, loosen the Inside Nut just
!
until the Gas Collector Box can be maneuvered and
turned upward.
The gap between the Spark Electrode Tip and Spark
!
receiver should be approximately 3/16".
AA BATTERY
INSIDE NUT
- 12 -
if the gap is wider than 3/16" use a pair of long nose pli-
!
ers and gently squeeze the Gas Collector Box until the
gap is correct.
! Return the Gas Collector Box to its original horizontal
position, secure the Inside Nut and try the Electrode
Check again.

lnstalling Cooking Components

Important: Before cooking on your grill for the first time,
wash the cooking grids and warming rack with warm, soapy
water. Rinse and dry thoroughly. Season with cooking oil
regularly. After cooking is completed, turn grill to HIGH set-
ting for about five minutes to burn off excess grease or food
residue.
1. Place the Ceramic Flame Tamers on the Ceramic Rack
and place on the lower ledge above the burners.
2. Evenly space the Stainless Steel Cooking Grids on the
ledge above the Flame Tamers.
3. Place the Upper Warming Rack into the holes on the
upper left and upper right of the back burner frame with
the bottom resting in the slots on either side of the grill
bowl.
Figure 15 UPPER
WARMING RACK
COOKING
GRID
CERAMIC
FLAME TAMER
POT
SUPPORT
CERAMIC
RACK