Before Using Your Grill - Barbeques Galore Y0662LP Owner's Manual

Grand turbo 52” bbq; 38” bbq; 27” bbq

Table of Contents

Although an obstructed burner tube is not the only cause of "FLASHBACK", it is the most common cause.

To reduce the chance of "FLASHBACK", you must clean the burner tubes before assembling your grill, and at least once

a month in late summer or early fall when spiders are most active. Also perform this burner tube cleaning procedure if your

grill has not been used for an extended period of time.

To reduce the chance of "FLASHBACK" clean the burner tubes and burners before fully assembling your grill.

Unscrew the bolt at the rear of the burner using a screwdriver. Carefully lift each burner up and away from the gas valve

orifice, then refer to Fig1 and perform one of these three cleaning methods:

1. Bend a stiff wire, (a lightweight coat hanger works well) into a small hook as shown below. Run the hook through the

burner tube and inside the burner several times to remove any debris.

2. Use a bottle brush with a flexible handle. Run the brush through the burner tube and inside the burner several times,

removing any debris.

3. Preferrably, an air hose should be used to force air through each burner tube. The forced air should pass debris or

obstructions through the burner and out the ports.

The location of the burner tube with respect to the orifice is

vital for safe operation. Check to ensure the orifice is inside

of the burner tube before using your gas grill (Figure 1).

If the burner tube does not fit over the valve orifice, lighting

the burner may cause explosion and/or fire.

Figure 2

TO CLEAN BURNER

TUBE INSERT HOOK

HERE

CAUTION: Spiders and small insects occasionally spin webs or make nests in the grill

burner tubes during transit and warehousing. These webs can lead to a gas flow

obstruction which could result in a fire in and around the burner tubes. This type of fire

is known as a "FLASHBACK" and can cause serious damage to your grill and create

an unsafe operating condition for the user.