Grill Lighting Instructions; Checking For Lp Gas Leaks - Barbeques Galore Y0662LP Owner's Manual

Grand turbo 52” bbq; 38” bbq; 27” bbq
Table of Contents

Advertisement

A strong gas smell, or the hissing sound of gas indicates a
serious problem with your gas grill or the LP gas tank.
Failure to immediately follow the steps listed below could
result in a fire or explosion that could cause serious bodily
injury, death, or property damage.
Shut off gas supply to the grill.
!
Turn the Control Knobs to the OFF position.
!
OPen grill lid.
!
!
Get away from the LP gas tank.
Do not try to fix the problem yourself..
!
If odor continues or you have a fire you cannot extin-
!
guish, call your fire department.
Do not call near the LP gas tank because your telephone is
an electrical device and could create a spark resulting in
fire and/or explosion.
NOTE: The normal flow of gas through the regulator and
hose assembly can create a humming noise. A low volume
of noise is perfectly normal and will not interfere with opera-
tion of the grill. If humming noise is loud and excessive you
may need to purge air from the gas line or reset the regula-
tor excess gas flow device. This purging procedure should
be done every time a new LP gas tank is connected to your
grill. For help call the Customer Service Helpline for assis-
tance.

Checking For LP Gas Leaks

Never test for leaks with a flame. Prior to first use, at the
beginning of each season, or every time your LP gas tank
is changed, you must check for gas leaks. Follow these
four steps:
1. Make a soap solution by mixing one part liquid deter-
gent and one part water.
2. Turn the grill control knobs to the full OFF position, then
turn the gas ON at source.
3. Apply the soap solution to all gas connections. If bub-
bles appear in the soap solution the connections are
not properly sealed. Check each fitting and tighten or
repair as necessary.
4. If you have a gas leak that you cannot repair, turn off
the gas at the source, disconnect fuel line from your grill
and call 1-800-474-5587 or your gas supplier for repair
assistance.
WARNING

Grill Lighting Instructions

Basic Lighting Procedures
1. Familiarize yourself with the safety guidelines at the front
of this manual. Do not smoke while lighting grill or check-
ing gas supply connections.
2. Be sure the LP gas tank is filled.
3. Check that the end of each burner tube is properly locat-
ed over each valve orifice.
4. Make sure all gas connections are securely tightened.
5. Open the Grill Lid or Side Burner Lid, depending on the
burner you are lighting.
Failure to open Grill Lid during the lighting procedures
could result in a fire or explosion that could cause seri-
ous bodily injury, death, or property damage.
6. Set control knobs to OFF and open the LP gas tank
valve slowly until 1/4 to 1/2 open.
Figure 18
OFF
7. Push and turn any control knob for Main Burner to
HIGH.
Figure 19
HIGH
8. Immediately press the electric ignitor for 3-4 seconds to
light the burner.
9. If the burner does not light, turn the control knob to
OFF, wait 5 minutes for gas to clear, then retry.
10. Once the grill burner is ignited, the adjacent burner can
be lit by simply turning its control knob to HlGH.
11. Adjust control knobs to your desired cooking tempera-
ture.
- 14 -
WARNING
Open LP
gas tank
OFF
ELECTRIC
IGNITER
CONTROL KNOBS
PRESS

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents