Before Embroidering; Embroidery Step By Step; Attaching Embroidery Foot "W2 - Brother 882-W07 Operational Manual

BEFORE EMBROIDERING

BEFORE EMBROIDERING

Embroidery Step by Step

Follow the steps below to prepare the machine for embroidery.
Step #
1 Presser foot attachment
2 Checking the needle
3 Embroidery unit attachment
4 Bobbin thread setup
5 Fabric preparation
6 Pattern selection
7 Embroidery frame attachment
8 Checking the layout
9 Embroidery thread setup
* It is recommended that a 90/14 needle should be used when embroidering on heavy weight fabrics or stabilizing products (for example;
denim, puffy foam, etc.). Ball point needle (golden colored) 90/14 is not recommended for embroidery.

Attaching Embroidery Foot "W2"

• When attaching a presser foot, always press
on the screen. You may accidentally
press the "Start/Stop" button and possibly
cause injury.
• Be sure to use embroidery foot "W2" or "W"
(optional) when doing embroidery. Using
another presser foot may cause the needle to
strike the presser foot, causing the needle to
bend or break and possibly cause injury.
186
Step 3
Step 1, 2
Step 7
Aim
Attach embroidery foot "W2".
Use needle 75/11 for embroidery. *
Attach the embroidery unit.
For the bobbin thread, wind embroidery bobbin thread and set it in place.
Attach a stabilizer material to the fabric, and hoop it in the embroidery frame.
Turn the main power to ON, and select an embroidery pattern.
Attach the embroidery frame to the embroidery unit.
Check and adjust the size and position of the embroidery.
Set up embroidery thread according to the pattern.
CAUTION
Step 9
Step 4
Step 5
Action
Memo
• Refer to Operation Manual Addendum, for
the detailed instructions how to use the
embroidery foot "W2".
a
Press the "Needle Position" button to raise
the needle.
Step 6, 8
Page
186
69
188
48
200
190
206
208
57