Overcasting Using The Side Cutter - Brother 882-W07 Operational Manual

■ Overcasting Using the Side Cutter

By using the side cutter, you can do overcasting while cutting the fabric.
• Recommended stitches are noted "S" in the lower right corner, therefore sure to only select one of these
stitches listed below. Using another stitch may cause the needle to hit the presser foot and break, possibly
causing injury.
Note
• Thread the needle manually when using the side cutter, or only attach the side cutter after threading
the needle using the "Automatic Threading" button.
Stitch Stitch name
With side cutter
With side cutter
With side cutter
With side cutter
With side cutter
a
Select a stitch.
b
Follow the steps on page 65 to remove the
presser foot.
c
Thread the needle (see page 57).
CAUTION
Presser
Applications
foot
Straight stitch while cutting
fabrics
Zigzag stitch while cutting fabrics
Overcasting stitch while cutting
fabrics
Overcasting stitch while cutting
fabrics
Overcasting stitch while cutting
fabrics
Stitch width
[mm (inch)]
Auto Manual
0.0 0.0 - 2.5
(0) (0 - 3/32)
3.5 3.5 - 5.0
(1/8) (1/8 - 3/16)
3.5 3.5 - 5.0
(1/8) (1/8 - 3/16)
5.0 3.5 - 5.0
(3/16) (1/8 - 3/16)
5.0 3.5 - 5.0
(3/16) (1/8 - 3/16)
d
Position the fork on the side cutter's
operating lever onto the needle clamp
screw.
a Needle clamp screw
b Operating lever
Memo
• Make sure that the fork of the operating
lever is set onto the needle screw firmly.
SEWING THE STITCHES
Stitch length
Twin
[mm (inch)]
needle
Auto Manual
2.5 0.2 - 5.0
NO
(3/32) (1/64 - 3/16)
1.4 0.0 - 4.0
NO
(1/16) (0 - 3/16)
2.0 1.0 - 4.0
NO
(1/16) (1/16 - 3/16)
2.5 1.0 - 4.0
NO
(3/32) (1/16 - 3/16)
2.5 1.0 - 4.0
NO
(3/32) (1/16 - 3/16)
3
107