Creating Bobbin Work (Sewing); Positioning The Fabric And Sewing - Brother 882-W07 Operational Manual

CREATING BOBBIN WORK (SEWING)

CREATING BOBBIN WORK (SEWING)

Positioning the Fabric and
Sewing
Note
• Recommended stitches for bobbin work are
open "airy" type stitches.
• Be sure to sew trial stitches using same
fabric and threads as project in order to
check the sewing results.
• The bobbin thread may become tangled due
to the type of pattern and thread that are
being used. Since this may cause the
needle to break, immediately stop sewing if
this occurs. Turn off the machine and cut out
the tangled thread with scissors. Then, clean
the race and bobbin case as described in
"Preparing the Bobbin Thread" on page 310.
a
Turn on the machine.
b
Select a stitch in the Utility and Decorative
Stitches mode. For this example, press
Memo
• For best results, select a longer stitch length
and a wider stitch width. Depending on the
selected stitch, it may not be possible to
change the stitch length and stitch width
settings.
• Depending on the fabric, bunched stitches
may result. We recommend selecting a
simple stitch and sewing trial stitches to
check the sewing results.
Examples of simple stitches:
314
c
Adjust the upper thread tension.
For details on adjusting the upper thread tension,
refer to "Setting the Thread Tension" on page 79.
Memo
We recommend a setting between 6 and 8 for the
upper thread tension.
d
Make sure the automatic thread cutting
(
reverse stitching (
off.
• Before sewing, make sure the automatic thread
cutting has been turned off. If sewing is started with
automatic thread cutting turned on, the thread may
become tangled or the machine may be damaged.
.
e
Place stabilizer on top (wrong side) of the
fabric.
Note
• Type and weight of stabilizer will depend on
fabric and thread being used.
f
If thread is too thick to pull through fabric
to machine surface use an awl to punch a
small hole in the fabric at the beginning of
stitching so the bobbin thread can be fed
through the opening.
, ,
g
Press
→ The screen changes, and all keys and operation
buttons are locked.
) and automatic reinforcement/
) have been turned
CAUTION
.