Pulling Up The Bobbin Thread - Brother 882-W07 Operational Manual

g
Pass the thread through the guide, and then
pull the thread out toward the front.
a Cutter
→ The cutter cuts the thread.
Note
• If the thread is not correctly inserted through
the tension spring of the bobbin case, it may
cause incorrect thread tension. (see page
79)
a Tension spring
CAUTION
• Be sure to hold down the bobbin with your
finger and unwind the bobbin thread
correctly. Otherwise, the thread may break or
the thread tension will be incorrect.
h
Insert the tab in the lower-left corner of the
bobbin cover (1), and then lightly press
down on the right side to close the cover
(2).
i
Press to unlock all keys and
buttons.

Pulling Up the Bobbin Thread

There may be some sewing applications where
you want to pull up the bobbin thread; for
example, when making gathers, darts, or doing
free motion quilting or embroidery.
Memo
• You can pull up the bobbin thread after
threading the upper thread ("UPPER
THREADING" on page 57).
a
Guide the bobbin thread through the
groove, following the arrow in the
illustration.
* Do not cut the thread with the cutter.
* Do not replace the bobbin cover.
b
While holding the upper thread, press the
"Needle Position" button to lower the
needle.
a "Needle Position" button
c
Press the "Needle Position" button to raise
the needle.
d
Press to lock all keys and buttons.
e
Gently pull the upper thread. A loop of the
bobbin thread will come out of the hole in
the needle plate.
LOWER THREADING
55
1