Brother 882-W07 Operational Manual page 355

Problem
Loops appear on the The thread tension is incorrectly set.
surface of the fabric
The tension of the upper thread is incorrectly set
when embroidering
for the combination of the fabric, thread and
pattern being used.
The combination of the bobbin case and bobbin
thread is incorrect.
Machine does not There is no pattern selected.
operate
"Start/Stop" button was not pushed.
Main power switch is not turned on.
Presser foot is not lowered.
"Start/Stop" button was pushed with the foot
controller attached.
The "Start/Stop" button was pressed while the
machine is set for the sewing speed controller to
control the zigzag stitch width.
All keys and buttons have been locked by
Embroidery unit does There is no pattern selected.
not operate
Main power switch is not turned on.
Embroidery unit is not attached correctly.
Embroidery frame was attached before the unit
was initialized.
Nothing happens, The screen has been locked.
even if the LCD
display is pressed
The fabric feeds in the The feed mechanism is damaged.
opposite direction.
The LCD screen is Condensation has formed on the LCD screen.
fogged up.
• This machine is equipped with a thread detection device. If the "Start/Stop" button is pushed before the
upper threading is done, the machine will not operate properly. Also, depending on the pattern selected,
the machine may feed the fabric even if the needle is raised. This is due to the needle bar release
mechanism. At these times, the machine will make a sound different from what is made during normal
sewing. This is not the sign of a malfunction.
• If the power is disconnected during sewing:
Turn the main power to OFF and unplug the machine.
If you restart the machine, follow the instructions for operating the machine correctly.
Cause
.
CAUTION
Solution
Adjust the thread tension.
Use the embroidery needle plate cover.
Change the bobbin case or bobbin thread so
that the correct combination is used.
Select a pattern.
Press the "Start/Stop" button.
Turn the main power to ON.
Lower the presser foot.
Remove the foot controller, or use the foot
controller to operate the machine.
Use the foot controller instead of the "Start/
Stop" button to operate the machine, or set
the Width control to OFF in the Sewing
settings.
Press to unlock all keys and
buttons.
Select a pattern.
Turn the main power to ON.
Reattach the embroidery unit correctly.
Perform the initialization process correctly.
Press either of the following keys to unlock the
screen.
Contact your dealer or the nearest authorized
service center.
After a while, the cloudiness will disappear.
TROUBLESHOOTING
Page
233 - 235
219
218
91, 156, 190, 265
15
26
15
73
35, 73
65, 67
190, 265
26
188
188
—
—
—
353
9