Brother 882-W07 Operational Manual page 64

UPPER THREADING
g
While holding the thread from the spool,
pull the thread through the lower notch in
the thread guide plate, then through the
upper notch. Hold the end of the thread
with your left hand, and then guide the
thread through the groove, following the
arrows in the illustration.
h
Continue threading however do not pass
the thread in the needle bar thread guide
"6" on the needle bar. Thread the needle on
the right side.
a Needle bar thread guide
i
Press
buttons.
j
Select a stitch pattern. (Example:
* Refer to the "STITCH SETTING CHART" at the end
of this manual for the proper stitch to use with
presser foot "J".
→ The selected stitch is displayed.
Note
• If the
the stitch, the selected stitch cannot be
sewn in the twin needle mode.
62
to unlock all keys and
key is light gray after selecting
k
Press
a
a Single needle/twin needle setting
→
• Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
)
l
Start sewing.
Sample of Twin Needle Sewing
Memo
• To change direction when sewing with the
twin needle, raise the needle from the fabric,
raise the presser foot lever, and then turn
the fabric.
to select the twin needle mode.
appears.
CAUTION