2.9
Connecting Serial Port Cable (RS-232) to
Camera
•
Remove the dome cover by undoing the four cover screws with
the supplied L-wrench.
•
Locate and unscrew the two screws on the internal camera as-
sembly connecting it to the base as shown in Figure 4. Do not
detach the screws from their base.
•
Locate the two plastic tabs shown in
towards the center of the dome as shown in Figure 4 and pull
the internal camera assembly away from the base to finalize the
removal process.
•
Locate the serial port connector shown in Figure 7.
Page 20
Figure 4. Gently push them
Figure 7
NetCam SC Vandal Resistant Dome