Table of Contents
Advertisement
To reinstall the internal camera assembly, line up the internal camera
assembly with the proper mounting holes and gently push it into the
dome base until the plastic tabs click into place.
•
Retighten the two screws. Do not over tighten as this my crack
the mounting holes on the internal camera assembly.
•
Reassemble the dome cover by reinstalling the four bolts with
the provided L-wrench. To maintain IP66 weatherproofing,
make sure to securely tighten the bolts so that there is little to no
gap between the dome cover and dome base. For an easier in-
stallation, tighten the screws by using a crisscross screw pattern
as shown in Figure 2.
NetCam SC Vandal Resistant Dome
Page 21
Advertisement
Table of Contents
