Table of Contents
Advertisement
2.7
Removing the Internal Camera Assembly
Removing the internal camera assembly will give you access to
the internal mounting holes [B,C] shown in Figure 1 and the interior
of the dome base area. The internal camera assembly does not need to
be removed to access the internal mounting holes for [A].
•
Remove the dome cover by undoing the four cover screws with
the supplied L-wrench.
•
Locate and unscrew the two screws on the internal camera as-
sembly connecting it to the base as shown in Figure 4. Do not
detach the screws from their base.
•
Locate the two plastic tabs shown in
towards the center of the dome as shown in Figure 4 and pull
the internal camera assembly away from the base to finalize the
removal process.
•
To reinstall the internal camera assembly, line up the internal
camera assembly with the proper mounting holes and gently
push it into the dome base until the plastic tabs click into place.
•
Retighten the two screws. Do not over tighten as this may crack
the mounting holes on the internal camera assembly.
•
Reassemble the dome cover by reinstalling the four bolts with
the provided L-wrench. To maintain IP66 weatherproofing,
make sure to securely tighten the bolts so that there is little to no
gap between the dome cover and dome base. For an easier in-
stallation, tighten the screws by using a crisscross screw pattern
as shown in Figure 2.
Page 18
Screw
Tab
Figure 4. Gently push them
Figure 4
NetCam SC Vandal Resistant Dome
Tab
Screw
Advertisement
Table of Contents
