Table of Contents
Advertisement
2.3
Installing NetCam SC Bottom to a Pipe
NOTE: To maintain IP66 weatherproofing, make sure to close up all unused
mounting holes with the provided screws and O-rings.
•
Remove the cap bolt and O-ring (if installed) by using a coin or
slotted screw driver and pass the desired wiring through the back
of the dome.
•
Connect the desired wiring and pull the wires through and into
the pipe.
•
Thread the dome onto the pipe. Make sure to completely cover
the pipe threads with Teflon tape to maintain weatherproofing.
•
During the installation of the dome onto the pipe, make sure
that the wiring does not get stuck to the Teflon tape, as this may
cause unnecessary damage to the wires and/or dome circuitry.
•
Once the dome is secured to the pipe, you can adjust the direc-
tion and focus of the lens.
•
To adjust the lens, remove the dome cover by undoing the four
cover screws with the supplied L-wrench.
•
Adjust the lens by pointing it in the desired direction. Use cau-
tion while adjusting the lens as the lens assembly will pan and
tilt with little effort. Using excessive force may cause damage to
the lens assembly.
•
Adjust the focus by rotating the lens focusing mechanism until
the desired focus is achieved. Depending on the type of lens
used, you may need to loosen and then tighten the lens locking
screw to complete this process.
•
Once you have finalized your adjustments, reassemble the dome
cover by reinstalling the four bolts with the provided L-wrench.
To maintain IP66 weatherproofing, make sure to securely tighten
the bolts so that there is little to no gap between the dome cover
and dome base. For an easier installation, tighten the screws by
using a crisscross screw pattern as shown in Figure 3.
Page 14
NetCam SC Vandal Resistant Dome
Advertisement
Table of Contents
