Parts Of Netcam Sc; Connecting Netcam Sc To A Network - StarDot Technologies NetCam SC User Manual

1.3

Parts of NetCam SC

1.4

Connecting NetCam SC to a Network

The StarDot Tools software can be used to find the camera's IP address
or to configure the camera with the Setup Wizard (optional).
 Install the StarDot Tools software by inserting the CD-ROM and
running setup.exe (it should run automatically).
 If your network has a router or server that auto assigns IP addresses
(DHCP), StarDot Tools will find the camera's IP address and display
it in the software. To access NetCam SC, simply double-click its IP
address. If the IP address is displayed, skip to Chapter 3.
 If your network does not auto-assign IP addresses, you can assign a
manual IP using a null serial cable. Connect one end of a null model
serial cable to the S1 port of NetCam SC and the other end into an
available serial port on your PC.
 Connect NetCam SC into a PoE switch or injector with a standard
CAT 5 network cable or with a StarDot Combo Ethernet/Power
Cable.
 In StarDot Tools, click the Setup Wizard button.
‘ Follow the steps in the Setup Wizard. If you're unsure of some of
the answers or you'd like more information on connecting NetCam
to the Internet or your private network, read the next section,
"An Overview of NetCam SC Connectivity".
Page 6
Auto Iris Jack (not shown)
For connecting DC auto iris lens
24VAC
Useful for legacy CCTV
Power Infrastructure
NET (PoE) 802.3af
100Mbit Power over Ethernet Port
S1 (Aux)
RS-232 Port, Optional Serial Configuration
Auxilliary Device Control
X )
( A U
S 1
A C
2 4 V
D C
E O
1 2 V
V I D
I / O
E )
P o
T (
N E
I/O (Input/Output)
Alarm Trigger Input / Relay Output
PWR (DC Power Jack)
10-20VDC
(500mA @ 12VDC)
VIDEO OUT
Analog Video
(NTSC or PAL)
NetCam SC