Table of Contents
Advertisement
2.6
Installing NetCam SC Side to Wall
NOTE: To maintain IP66 weatherproofing, make sure to close up all unused
mounting holes with the provided screws and O-rings.
Since the NetCam SC uses a two axis gimbal, we recommend
using a wall mount (Part Number: MNT-VWAL) for this type of wall
installation. (Wall Mount is not included)
•
Follow Wall Mount instructions to install wall mount (Part Num-
ber: MNT-VWAL).
•
Connect the desired cables and make sure that they will not get
caught or damaged during the installation process.
•
Remove the dome cover by undoing the four cover screws with
the supplied L-wrench.
•
Mount the dome onto the ceiling by using mounting holes [A]
as shown in Figure 1. If you are drilling a wiring hole in the
ceiling/wall, make sure that the hole diameter is within 30 mm.
To maintain IP66 weatherproofing, make sure to also use and
correctly align the provided gasket with the hole to insulate the
ceiling/wall and dome base.
•
Once the dome is secured to the ceiling/wall, you can adjust the
lens and focus.
•
To adjust the lens, remove the dome cover by undoing the four
cover screws with the supplied L-wrench.
•
Adjust the lens by pointing it in the desired direction. Use cau-
tion while adjusting the lens as the lens assembly will pan and
tilt with little effort. Using excessive force may cause undo
damage to the lens assembly.
•
Adjust the focus by rotating the lens focusing mechanism until
the desired focus is achieved. Depending on the type of lens
used, you may need to loosen and then tighten the lens locking
screw to complete this process.
•
Once you have finalized your adjustments, reassemble the dome
cover by reinstalling the four bolts with the provided L-wrench.
To maintain IP66 weatherproofing, make sure to securely tighten
the bolts so that there is little to no gap between the dome cover
and dome base. For an easier installation, tighten the screws by
using a crisscross screw pattern as shown in Figure 2.
NetCam SC Vandal Resistant Dome
Page 17
Advertisement
Table of Contents
