Serial Port Settings; Ip Address Settings - D-Link xStack DES-3200-10 User Manual

xStack

Serial Port Settings

The following window allows the Baud Rate and the Auto Logout to be changed as well as containing information
about the Serial Port Settings.
Click Configuration > Serial Port Settings to display this window:
Parameter
Baud Rate
Auto Logout
Click Apply to implement changes made.
NOTE: If a user configures the serial port's baud rate, the baud rate will take effect and save
immediately.

IP Address Settings

The IP address may initially be set using the console interface prior to connecting to it through the Ethernet. If the
Switch IP address has not yet been changed, read the introduction of the DES-3200-10/18/28/28F CLI Reference
Manual for more information.
Click Configuration > IP Address Settings to display the following window:
To manually assign the Switch's IP address, subnet mask, and default gateway address:
1. Click Static at the top of the window.
2. Enter the appropriate IPv4 Address and Subnet Mask.
3. To access the Switch from a different subnet from the one it is installed on, enter the IP address of the
Gateway. If the Switch will be managed from the subnet on which it is installed, leave the default address
(0.0.0.0) in this field.
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Figure 2 - 3. Serial Port Settings window
Description
This field specifies the baud rate for the serial port on the Switch. There are four possible
baud rates to choose from, 9600, 19200, 38400 and 115200. For a connection to the Switch
using the CLI interface, the baud rate must be set to 9600, which is the default setting.
Select the logout time used for the console interface. This automatically logs the user out after
an idle period of time, as defined. Choose from the following options: 2 Minutes, 5 Minutes, 10
Minutes, 15 Minutes or Never. The default setting is 10 minutes.
Figure 2 - 4. IP Address Settings window
14