D-Link xStack DES-3200-10 User Manual page 179

xStack
The following parameters may be configured for the IPv6:
Parameter
Access ID (1-5)
Flow Label
Action
Time Range Name
Ports
Click Apply to display the following Access Rule List window:
To view the configurations for a previously configured rule, click on the corresponding Show Details button, which will
display the following CPU Access Rule Detail Information window:
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Figure 6 - 45. (CPU) Add Access Rule window for IPv6 example
Description
Type in a unique identifier number for this access. This value can be set from 1 to 5.
Specifies the IPv6 Flow Label. Enter a value between 0 – FFFFF.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify the packets that match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port
defined in the config mirror port command. Port Mirroring must be enabled and a target port
must be set.
Tick the check box and enter the name of the Time Range settings that has been previously
configured in the Time Range Settings window. This will set specific times when this
access rule will be implemented on the Switch.
Enter a range of ports to be configured.
Figure 6 - 46. CPU Access Rule List window for IPv6 example
178