Lldp Global Settings - D-Link xStack DES-3200-10 User Manual

xStack

LLDP Global Settings

To view this window, click L2 Features > LLDP > LLDP Global Settings:
The following parameters can be set:
Parameter Description
LLDP State Used to enable or disable LLDP on the Switch.
LLDP Forward When LLDP is Disabled this function controls the LLDP packet forwarding message based on
Message individual ports. If LLDP is enabled on a port it will flood the LLDP packet to all ports that have
the same port VLAN and will advertise to other stations attached to the same IEEE 802 LAN.
Message Tx This interval controls how often active ports retransmit advertisements to their neighbors. To
Interval change the packet transmission interval, enter a value in seconds (5 to 32768).
(5-32768)
Message Tx Hold This function calculates the Time-to-Live for creating and transmitting the LLDP advertisements
Multiplier (2-10) to LLDP neighbors by changing the multiplier used by an LLDP Switch. When the Time-to-Live
for an advertisement expires the advertised data is then deleted from the neighbor Switch's MIB.
LLDP Reinit The LLDP reinitialization delay interval is the minimum time that an LLDP port will wait before
Delay (1-10) reinitializing after receiving an LLDP disable command. To change the LLDP Reinit Delay, enter
a value in seconds (1 to 10).
LLDP Tx Delay LLDP TX Delay allows the user to change the minimum time delay interval for any LLDP port
(1-8192) which will delay advertising any successive LLDP advertisements due to change in the LLDP
MIB content. To change the LLDP TX Delay, enter a value in seconds (1 to 8192).
LLDP Notification LLDP Notification Interval is used to send notifications to configured SNMP trap receiver(s) when
Interval (5-3600) an LLDP change is detected in an advertisement received on the port from an LLDP neighbor.
To set the LLDP Notification Interval, enter a value in seconds (5 to 3600).
Click Apply to implement changes made.
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Figure 3 - 50. LLDP Global Settings window
100