D-Link xStack DES-3200-10 User Manual page 165

xStack
Click on the boxes at the top of the table, which will then turn red and reveal parameters for configuration. To create a
new entry enter the correct information and click Create. To return to the Access Profile List window, click <<Back.
The following parameters can be set for Packet Content:
Parameter Description
Tick either Source MAC Mask and enter the MAC source address mask or Destination MAC Mask
MAC Address
and enter the MAC destination address mask.
Tick Customer Tag (0-FFFF) and enter the appropriate customer tag, in hex form (hex 0x0-0xffff),
Tag
and/or Service Tag (0-FFFF) and enter the appropriate service tag, in hex form (hex 0x0-0xffff).
Allows users to examine up to eleven specified offset packet content chunks within a packet at
Packet Content
one time and specifies the frame content offset, mask, and layer. There are eleven packet content
chunk offsets that can be configured. A packet content chunk mask presents two bytes. Up to
eleven packet content offset chunks can be selected:
Offset 1 (0-31) _____mask______Layer ___,
Offset 2 (0-31) _____mask______Layer ___,
Offset 3 (0-31) _____mask______Layer ___,
Offset 4 (0-31) _____mask______Layer ___,
Offset 5 (0-31) _____mask______Layer ___,
Offset 6 (0-31) _____mask______Layer ___,
Offset 7 (0-31) _____mask______Layer ___,
Offset 8 (0-31) _____mask______Layer ___,
Offset 9 (0-31) _____mask______Layer ___,
Offset 10 (0-31) _____mask______Layer ___,
Offset 11 (0-31) _____mask______Layer ___
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Figure 6 - 22. Add ACL Profile window for Packet Content example
164