Power Button Board - HP Split 13 x2 PC Maintenance And Service Manual

Power button board

Description
Power button board
NOTE: The power button board does not include the power button board cable. The power
button board cable is included in the Cable Kit, spare part number 736883-001. See
on page 23 for more Cable Kit spare part information.
Before removing the power button board, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4.
Remove the back cover (see
5.
Remove the tablet battery (see
Remove the power button board:
1. Release the zero insertion force (ZIF) connector (1) to which the power button board cable is
attached, and then disconnect the power button board cable from the system board.
2. Remove the Phillips PM2.0×3.0 screw (2) that secures the power button board to the
display assembly.
3. Remove the power button board (3) and cable.
Reverse this procedure to install the power button board.
Back cover on page 38).
Tablet battery on page
Spare part number
736889-001
Cable Kit
40).
Removal and replacement procedures
49