Hard Drive - HP Split 13 x2 PC Maintenance And Service Manual

Hard drive

Description
500-GB, 5400-rpm, SATA, 5.0-mm hard drive (does not include hard drive bracket, hard drive
connector cable, or screws)
NOTE: The hard drive bracket, hard drive connector cable, and screws are included in the Hard
Drive Hardware Kit, spare part number 736884-001.
Before removing the hard drive, follow these steps:
1.
Turn off the tablet and keyboard base. If you are unsure whether the tablet and keyboard base are
off or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2.
Disconnect the power from the tablet and keyboard base by unplugging the power cord from the
tablet and keyboard base.
3. Disconnect the tablet from the keyboard base.
4. Remove the bottom cover (see
5. Remove the keyboard base battery (see
6. Remove the power connector board (see
Remove the hard drive:
1. Release the grounding tape (1) that secures the hard drive to the keyboard/top cover.
2. Remove the four Phillips PM2.0×3.0 screws (2) that secure the hard drive to the keyboard/
top cover.
76 Chapter 4 Removal and replacement preliminary requirements
Bottom cover on page 68).
Keyboard base battery on page
Power connector board on page
Spare part number
737957-005
70).
74).