Keyboard Base Component Replacement Procedures; Bottom Cover - HP Split 13 x2 PC Maintenance And Service Manual

Keyboard base component replacement procedures

CAUTION:
an authorized service provider. Accessing these parts can damage the keyboard base and void
the warranty.
This chapter provides removal and replacement procedures for authorized service provider only parts.
There are as many as 35 screws that must be removed, replaced, and/or loosened when servicing
the keyboard base. Make special note of each screw size and location during removal
and replacement.

Bottom cover

Description
Bottom cover (includes rubber feet)
Before disassembling the keyboard base, follow these steps:
1. Turn off the tablet and keyboard base. If you are unsure whether the tablet and keyboard base are
off or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2. Disconnect the power from the tablet and keyboard base by unplugging the power cord from the
tablet and keyboard base.
3. Disconnect the tablet from the keyboard base.
Remove the bottom cover:
1. Remove the four Phillips PM2.0×4.25 screws (1) that secure the bottom cover to the keyboard/
top cover.
2. Remove the rubber feet (2).
NOTE:
68 Chapter 4 Removal and replacement preliminary requirements
Keyboard base components described in this chapter should only be accessed by
The rubber feet are available in the Rubber Kit, spare part number 736897-001.
Spare part number
736882-001