Power Button Board - HP ElitePad 1000 G2 Maintenance And Service Manual

Power button board

Description
For use only on computer models equipped with the Windows 10 or Windows 8 Professional
operating system
For use only on computer models equipped with the Windows 10 or Windows 8 Standard
operating system
For use only on tablet models equipped with the Windows 10 or Windows Embedded Industry 8.1 64-bit
Retail Solutions operating system
For use only on computer models equipped with a non-Windows 10 or Windows 8 operating system
Before removing the power button board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display assembly (see
5. Remove the NFC antenna (see
6. Disconnect the left microphone cable from the power button board (see
7. Disconnect the rear-facing webcam cable from the power button board (see
on page
Remove the power button board:
1. Disconnect the volume button board cable (1) from the power button board.
2. Release the support strip (2) that secures the WWAN antenna transceiver to the battery.
3. Release the support strip (3) that secures the power button board cable to the system board.
4. Release the ZIF connector (4) to which the power button board cable is attached, and then disconnect
the power button board cable from the system board.
42 Chapter 5 Removal and replacement procedures
NFC antenna on page
41).
Display assembly on page
35).
Spare part number
753976-601
753976-501
753976-401
753976-001
28).
Microphones on page
Rear-facing webcam
40).