Table of Contents
Advertisement
Locomotive switch function overview
Locomotive switch location
The switches that control the features and programing of your locomotive are located under the
SWITCH
SWITCH
drop down door section under the cab on the engineer's side of the locomotive (see Figure 2, page
10). When you drop down the door these switches are visible with their icons. Icons on the right
SWITCH
hand side show the ON or RUN positions. Icons on the left hand side show the OFF or PROGRAM
positions. On the inside of the drop down door, there is also a legend with words that help describe
SWITCH
the function of each switch.
SWITCH
SWITCH
Looking at the switches from left to right they are as follows:
OFF
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
PROGRAM
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
Sound controls
OFF
-
Figure 1. Locomotive switch functions
ON
Smoke Unit Switch
Used to turn the main smoke stack unit function "ON" and "OFF".
This switch is "read" by your engine at start-up. Switching it after start-up will
have no effect.
Odyssey II Speed Control System Switch
Used to turn the Odyssey II Speed Control System "ON" and "OFF".
Program Run Switch
Used to assign an ID# and reprogram the locomotive in LEGACY and Command
operation when the switch is in the "PROG" position. Also used to "lock" your
locomotive in a single direction, or neutral, in conventional operation when the
RUN
switch is placed in the "PROG" position. See pages 21, 27, and 31.
RailSounds ON/OFF Switch
Used to turn off all sounds except horn and bell.
ON
Volume UP/DOWN Control
Used to turn the maximum volume up or down.
+
9
Meijer.com
Advertisement
Table of Contents
