Wiring your Icing Station Placing your Icing Station on your layout Operating your Icing Station Notes Limited Warranty/Lionel Service The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel ® , TrainMaster ®...
3. Attach a final wire to the separate switch and connect it to the Common/Ground/U terminal on the power supply or the #2 terminal on the Lionel Lockon. FasTrack users, twist the end of the wire to the remaining Accessory Power Wire and insulate the connection.
Placing your Icing Station on your layout lace the Icing Station along a straight section of track that is at least 11 inches long. If the station is located between two parallel tracks, allow at least six inches between the tracks.
(included)! Follow these steps and refer to Figure 4 as you operate this accessory. 1. Stock the Icing Station by sliding the ice blocks into the depot building. Raise the upper chute and slide the ice cubes into the back of the building. The cubes will slide down the chute on the opposite, ready to be loaded.
Lionel L.L.C. or an authorized Lionel L.L.C. Service Center, together with proof of original purchase will, at the option of Lionel L.L.C., be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a replacement is not available, a refund of the original purchase price will be granted.
Need help?
Do you have a question about the Icing Station and is the answer not in the manual?
Questions and answers