Advertisement
Quick Links
Advertisement
Related Manuals for Lionel 352 Icing Station
Summary of Contents for Lionel 352 Icing Station
- Page 1 71-2703-250 9/01 Lionel 352 Icing Station Owner’s Manual...
-
Page 2: Table Of Contents
Placing your 352 Icing Station on your layout Operating your 352 Icing Station Notes Limited Warranty/Lionel Service The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel ® , TrainMaster ®... -
Page 3: Assembling Your 352 Icing Station
Assembling your 352 Icing Station et up this action-packed accessory! Follow these steps and refer to Figure 1 as you assem- ble your Icing Station. 1. Attach the lower chute. Insert the large tab into the slot on the top plat- form, then insert the two bottom hooks into the two slots on the lower platform. -
Page 4: Wiring Your 352 Icing Station
Wiring your 352 Icing Station ou may choose to power your Icing Station with a Lionel LockOn, your transformer, or a separate accessory power supply. This accessory requires 12-18 volts (AC). Refer to Figure 2 for the complete wiring diagram. -
Page 5: Placing Your 352 Icing Station On Your Layout
Placing your 352 Icing Station on your layout lace the Icing Station along a straight section of track that is at least 11 inches long. If the station is located between two parallel sections of track, allow at least six inches between the tracks. -
Page 6: Operating Your 352 Icing Station
Operating your 352 Icing Station ou are ready to load your ice cars (available separately)! Follow these steps and refer to Figure 4 as you operate this accessory. 1. Stock the Icing Station by sliding the ice blocks into the depot building. -
Page 7: Notes
Notes... -
Page 8: Limited Warranty/Lionel Service
Center, together with proof of original purchase above instructions carefully before returning any will, at the option of Lionel L.L.C., be repaired or merchandise for service. You may choose to have replaced, without charge for parts or labor. In the...