Lionel 3360 Burro Crane Owner's Manual

Lionel 3360 Burro Crane Owner's Manual

Lionel toys#3360 burro crane

Advertisement

72-8414-250
11/05
Lionel
#3360 Burro Crane
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3360 Burro Crane and is the answer not in the manual?

Questions and answers

Summary of Contents for Lionel 3360 Burro Crane

  • Page 1 72-8414-250 11/05 Lionel #3360 Burro Crane Owner’s Manual...
  • Page 2: Table Of Contents

    Lubricating your Burro Crane Lubricating the Pullmor motor armature bearings Replacing the traction tire Limited Warranty/Lionel Service The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel ® , TrainMaster ®...
  • Page 3: Using The Burro Crane With Track Actuators

    Using the Burro Crane with track actuators wo track actuators are included with the Burro Crane. The track actuators change the position of the direction control switch, reversing the direction of the crane. The direction control switch is illustrated in Figure 2 on page 4. •...
  • Page 4: Operating The Burro Crane

    Operating the Burro Crane (continued) Moving the unit To move the unit along the rails, simply apply track power. Increase the voltage to make the unit travel faster. To change directions, pass an actuator that has been positioned along the rails or throw the direction control switch by hand. The Burro Crane was designed to pull only one or two cars.
  • Page 5: Lubricating Your Burro Crane

    We recommend that you purchase a Lionel Lubrication and Maintenance Kit (6-62927), available from your authorized Lionel dealer. Two basic rules to keep in mind: never over-lubricate (a small amount will do) and avoid getting grease or oil on the wheels, pick-ups, or your track.
  • Page 6: Lubricating The Pullmor Motor Armature Bearings

    Burro Crane will require the occasional lubrication of its Pullmor motor armature. If you hear excess noise during operation, or if the unit slows down intermittently, you may need to oil the armature bearings. We recommend that you purchase a Lionel Lubrication and Maintenance Kit (6-62927) to properly service your Burro Crane.
  • Page 7 3. Remove the set screw from the top of the motor using a 3/64” Allen wrench. This screw is illustrated in Figure 5. 4. Add a small amount (two drops) of Lionel oil (available in the Lubrication and Maintenance Kit, no. 6-62927) to the set screw hole.
  • Page 8: Limited Warranty/Lionel Service

    Lionel L.L.C. or an authorized Lionel L.L.C. Service Center, together with proof of original purchase will, at the option of Lionel L.L.C., be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a replacement is not available, a refund of the original purchase price will be granted.

Table of Contents