Locomotive Switch Function Overview; Locomotive Switch Location - Lionel VISION ATSF 3000 2-10-10-2 Owner's Manual

Locomotive switch function overview

SWITCH
SWITCH

Locomotive switch location

The switches that control the features and programing of your locomotive are located under
the sand dome hatch in front of the cab. When you lift up the hatch these switches are
visable with their icons. Icons on the left hand side show the ON or RUN positions. Icons on
SWITCH
SWITCH
SWITCH
the right hand side show the OFF or PROGRAM positions. On the inside of the lift off hatch,
there are also words that help describe the function of each switch.
Looking down at the locomotive with the front facing to the right the switches are as follows:
SWITCH
SWITCH
SWITCH
SWITCH
PROGRAM
SWITCH
ON
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
Sand dome hatch
SWITCH
Program Run switch and
SWITCH
Odyssey II Speed Control
SWITCH
Front of Locomotive
Figure 2. Locomotive switch locations
SWITCH
71-1155-250 ATSF 3000.indd 8
Program Run Switch
Used to assign an ID# and reprogram the locomotive in LEGACY and
Command operation when the switch is in the "PROG" position.
Also used to "lock" your locomotive in a single direction, or neutral,
RUN
in conventional operation when the switch is placed in the "PROG"
position. See pages 21, 27, and 31.
OFF
Odyssey II Speed Control System Switch
Used to turn the Odyssey II Speed Control System "on" and "off".
Smoke Unit Switch
Used to turn the main smoke stack unit function "on" and "off".
This switch is "read" by your engine at start-up. Switching it after
start-up will have no effect.
Whistle Steam Switch
Used to turn the whistle and blowdown steam effect "on" and "off".
This switch is "read" by your engine at start-up. Switching it after
start-up will have no effect. NOTE: This switch does NOT control
Sound!
Rear of Locomotive
Sand dome hatch
Smoke Unit Switch
Front of Locomotive
8
Rear of Locomotive
4/28/10 8:35 AM