Locomotive Switch Function Overview; Locomotive Switch Locations - Lionel VISION 4-6-6-4 Challenger Owner's Manual

Locomotive switch function overview

Locomotive switch locations

T
he switches that control the features and programing of your locomotive are located under
the sand dome hatch in front of the cab. When you lift up the hatch these switches are
visible with labels.
Looking down at the locomotive with the front facing to the right the switches are as follows:
Smoke Unit Switch (MAIN SMK)
Used to turn the main smoke stack unit function on and off. This switch is "read" by your engine at
start-up only. Switching it after start-up will have no effect.
Whistle Steam Switch (WHISTLE)
Used to turn the whistle steam effect on and off. This switch is "read" by your engine at start-up
only. Switching it after start-up will have no effect. NOTE: This switch does NOT control Sound!
Dynamo/Injector Steam Switch (DYNAMO/INJECTOR)
Used to turn the dynamo and injector steam effects on and off. This switch is "read" by your
engine at start-up only. Switching it after start-up will have no effect. NOTE: This switch does NOT
control Sound!
Program-Run Switch
Used to assign an ID# and reprogram the locomotive in LEGACY and Command operation when the
switch is in the PGM position. Also used to "lock" your locomotive in a single direction, or neutral, in
conventional operation when the switch is placed in the PGM position. See pages 21, 27, and 31.
Odyssey II Speed Control System Switch (ODY)
Used to turn the Odyssey II Speed Control System on and off.
ON OFF
MAIN SMK
RUN
ON OFF
WHISTLE
ON
ON OFF
DYNAMO/INJECTOR
Front of Locomotive
Figure 2. Locomotive switch locations
PGM
OFF
ODY
8
Rear sand dome hatch
Rear of Locomotive