LEGACY RailSounds sound system operations
Installing the battery
A
lthough the LEGACY RailSounds sound system is powered through the track, we
recommend that you install a nine-volt alkaline battery in the locomotive to prevent
the sound system from shutting down during track power interruptions (for example,
at a switch or a dirty section of track). Follow these steps and see below as you install
the battery.
If the RailSounds sound system turns off during interruptions in track power,
Note!
you may need to replace the battery.
1. Remove the hatch from the front nose of the locomotive by lifting upthen away. See
Figure 3 below.
2. Remove the protective cover from the battery harness.
3. Snap the battery harness onto the nine-volt alkaline battery's terminals.
4. Slide the battery into the battery well in the nose cavity.
5. Replace the hatch on the nose of the locomotive. See Figure 3 below.
Figure 3. Installing the battery in the locomotive
11
Meijer.com