Compliance With Standards And Regulations - Buderus Logano G315 Installation And Service Instructions Manual

2.3 Compliance with standards and
regulations
Installation and operation of the system must comply with
all applicable codes, regulations and statutory
requirements.
Installation, connection of the fuel supply and flue
connector, commissioning, connection of the electrical
power supply, servicing and repair may only be carried out
by a trained or certified heating contractor. Only
registered gas fitters may carry out work on the gas train.
The system must be cleaned and serviced once a year.
The operation of the complete system must be tested at
the same time. Any faults must be corrected immediately.
The design and mode of operation of this boiler must
comply with the American National Standard ANSI
Z21.13/CSA4.9, latest edition for Gas Fired Low
Pressure Steam and Hot Water Boilers.
Other confirmed approvals and certifications are
indicated by labels on the boiler.
The heat exchanger has been designed and certified in
accordance with the ASME Boiler and Vessel Code,
Section IV.
Installation of the boiler must comply with all applicable
codes and regulations imposed by the national, Federal or
local authorities and bodies. If no specific requirements
are defined, in the USA, the latest edition of the National
Fuel Gas Code ANSI Z223.1/NFPA 54 applies. In
Canada, installation must comply in all respects with the
latest edition of the Installation Code for Gas Burning
Appliances and Equipment, CAN/CSA-B.149 and the
applicable local regulations and requirements for the
appliance category. The relevant authorities and
regulatory bodies must be informed before installation
starts.
Where required by local regulations, the system must
comply with the American Society of Mechanical
Engineers Safety Code for Controls and Safety Devices
for Automatically Fired Boilers (ASME CSD-1).
The hot water distribution system must comply with all
applicable codes and regulations. When replacing an
existing boiler, it is important to check the condition of the
entire hot water distribution system to ensure safe
operation.
In the Commonwealth of Massachusetts, this appliance
must be installed by a licensed plumber and gas fitter.
Valves external to the boiler must be fitted with T-handles
and condensate piping must be installed in accordance
with the State Plumbing Code.
Logano G315 - Subject to technical modifications
Product description
2
9