Positioning The Boiler; Tools And Auxiliary Materials; Boiler Assembly Tool Size 2.3 - Buderus Logano G315 Installation And Service Instructions Manual

6

Positioning the boiler

This chapter describes how to properly position the
Logano G315.
NOTICE: Risk of system damage from
freezing.
B Install the system in a room free from the
danger of freezing.
6.1

Tools and auxiliary materials

The following tools and auxiliary materials are required for
the boiler assembly (the listed items must be provided by
the installer):
• Boiler assembly tool 2.3 (
• Installation kit (accessory)
• Steel hammer and wooden or rubber mallet
• Half-round bastard file
• Screwdriver (Philips and flat head)
• Flat chisel
• Metric wrenches
• Support wedge, flat iron
• Cleaning rags and cloth
• Fine emery cloth
• Wire brush
• 3-in-1 oil
• Solvent (gasoline, mineral spirits)
• Spirit level, tape measure, chalk, straight edge
• Blanking flange with vent facility (for pressure test)
Logano G315 - Subject to technical modifications
Fig. 4)
Positioning the boiler
6.1.1

Boiler assembly tool size 2.3

4
L
2
3 2 1
Fig. 4 Boiler assembly tool size 2.3
1 Mating flange
2 Additional flange
3 Compression unit (pressure flange with clamping nut)
4 Tie rod
5 Extension
6 Wedge (size 2.3)
L 121-1/4" (3080 mm)
1
L 31-1/2" (800 mm)
2
Assembly
Boiler tool(s) per
sections boiler hub
5 – 9 1
Tab. 7
For the correct arrangement of the flange
when performing the assembly procedure,
refer to page 22.
5
L
1
L
2
6
6 720 642 623-03.1o
Extension Length (total)
piece per in inches
boiler hub (mm)
121-1/4
3
(3080 mm)
6
15