Page 1
These instructions are available in English and French. Please keep these instructions for future reference. Operating Instructions Logano G315 Low temperature boilers for oil/gas fired power burners Read carefully before carrying out installation and maintenance.
Contents Contents Key to symbols and safety instructions Key to symbols Key to symbols and safety instructions ....2 Warnings Key to symbols ....... . . 2 Warnings in this document are identified by a warning General safety instructions .
▶ Immediately correct all faults to prevent system damage. ▶ If you hear gas escaping, evacuate the affected area immediately. ▶ Use only original Buderus spare parts. Damage caused by the use of ▶ Open the windows. spare parts not supplied by Buderus are excluded from the Buderus ▶...
Any other purpose is considered improper use. Any resulting damage is excluded from the manufacturer's warranty. The Logano G315 can be operated with oil, gas, and dual fuel burners. For a list of the approved burners, please contact Bosch Thermotechnology Corp.
Product description Water quality requirements NOTICE: System damage from corrosion or scale All water contains substances, e.g. Ca (HCO (calcium hydrogen formation as the result of using fill and make-up water carbonate) that could affect the operation of your heating system. These that does not conform to the system-specific can cause corrosion, scale formation or deposits potentially affecting requirements.
System start-up 3.2.1 Checking the operating water pressure System start-up The operating water pressure must be at least 15 psi (1 bar). This chapter explains how you prepare the system for operation and how ▶ Read the current operating pressure and temperature ( °F ( °C)) on to commission the control panel and the burner.
Shutting down the system Using a Hydrolevel Hydrostat® Switching off the control panel and the burner Shut down your boiler via the main power switch or designated circuit The Hydrolevel Hydrostat® control is for oil applications breaker. The burner is automatically shut down when the main power is only! switched off.