Intended Use; Regulations And Guidelines; National Regulations; Compliance With Standards And Regulations - Buderus Logano plus SB615 Installation And Servicing Instructions

2

Intended use

The Buderus Logano SB615 steel boiler is a condensing
boiler for operation with a fan-assisted gas burner. The
boiler may only be used for heating central heating system
water and indirect heating of domestic hot water (using a
heat exchanger or indirect fired hot water tank), for in-
stance in apartment buildings.
3

Regulations and guidelines

3.1

National regulations

The heating system must comply with the requirements of
the relevant regulatory authorities or otherwise of the Nati-
onal Fuel Gas Code, ANSI Z 223.1. In Canada, the require-
ments of CAN/CGA-B.149.1 and 2, Installation Code for
Gas Burning Appliances and Equipment, must be obser-
ved.
If specified by the relevant regulatory authorities, the
heating system must comply with the regulations of the
Standard for Controls and Safety Devices for Automatical-
ly Fired Boilers, ANSI/ASME CSD-1.
Carbon monoxide detectors must be installed as specified
by the local regulations. The boiler must be serviced annu-
ally.
3.2 Compliance with standards and
regulations
Installation of the boiler must comply with all applicable co-
des and regulations imposed by the national, Federal or lo-
cal authorities and bodies. If no specific requirements are
defined, in the USA, the latest edition of the National Fuel
Gas Code ANSI Z223.1/NFPA 54 must be complied with.
In Canada, installation must comply in all respects with the
latest edition of the Installation Code for Gas Burning
Appliances and Equipment, CAN/CGA-B.149 and the
applicable local regulations and requirements for the
appliance category. The relevant authorities and regulatory
bodies must be informed before installation starts.
Where required by local regulations, the system must com-
ply with the American Society of Mechanical Engineers
Safety Code for Controls and Safety Devices for Automati-
cally Fired Boilers (ASME CSD-1).
For boiler rating plate remove left front panel.
In the Commonwealth of Massachusetts, this appliance
must be installed by a licensed pipe fitter, taps external to
the boiler must be fitted with T-handles and condensate pi-
ping must be fitted in accordance with the State Plumbing
Code.
Logano plus SB615 - Technical specifications are subject to change without prior notice.
RISK OF FATAL INJURY
from explosion of flammable gases.
WARNING! Installation, connection of the fuel supply
and flue pipe, commissioning, connec-
tion of the electrical poower supply, ser-
vicing and repair may only be carried out
by an authorized heating engineer.
Any work on gas-carrying components
may only be carried out by an authorized
gas installer.
The local regulations regarding minimum pressure detec-
tors and low-water safety cutouts must be observed. Instal-
lation and operation must comply with the device
manufacturer's technical documentation.
We recommend fitting an 80 mesh dirt filter externally to
the boiler return to prevent contamination of the boiler by
the water.
Leak test
A leak test must be carried out. The testing pressure is
based on the normal operating pressure of the heating
system and should be 1.3 times that pressure, and in
any case no less than 14 psi (1 bar).
USER NOTE
The details on the boiler rating plate are de-
finitive and must be observed.
Intended use 2
5