MOVING A FREQUENCY FROM THE
MONITOR MEMORY TO A CHANNEL
1. Press MANUAL, enter the channel number where you
want to store the frequency, then press PGM. PGM, the
frequency number or 000.0000, and the selected chan-
nel number appear.
2. Press MON. MON and the frequency appear and the chan-
nel number flashes.
3. Press E. MON disappears, the channel number stops
flashing, and the scanner stores the frequency in the se-
lected channel.
MONITORING A STORED CHANNEL
You can continuously monitor a specific channel without
scanning. This is useful if you hear an emergency broadcast
on a channel and do not want to miss any details - even
though there might be periods of silence - or if you simply
want to monitor that channel.
Follow these steps to manually select a channel.
1. Press MANUAL.
2. Enter the channel number.
3. Press MANUAL again.
SCANNING THE CHANNELS
To begin scanning channels or to start scanning again after
monitoring a specific channel, press SCAN.
SCAN and /\ appear, and the scanner begins to rapidly scan
upward until it finds an active frequency.
If the scanner finds an active frequency, it stops and dis-
plays that channel and frequency number, then it automati-
cally begins scanning again when the transmission ends on
that frequency.
Notes:
h You must store frequencies into channels before the scan-
ner can scan them.
h To change the scanning direction, press /\ or \/.
h The scanner does not scan empty channels.
15