Table of Contents
Advertisement
Remove the sensor board:
1.
Disconnect the sensor board cable from the ZIF connector on the system board (1).
2.
Pull the cable out from under the antenna cable that connects to the integrated WLAN module (2).
3.
Remove the sensor board from the computer (3).
Reverse this procedure to install the sensor board. Run the camera function test after the repair. For more
information, see
Power button
To remove the power button, use this procedure and illustration.
Table 5-6
Power button descriptions and part numbers
Description
Power button
Power button cable
Power button bracket
Fingerprint reader module
Before removing the power button, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the display assembly (see
3.
Disconnect the battery cable from the system board (see
Remove the power button:
1.
Disconnect the power button cable from the ZIF connector on the system board (1).
2.
Remove the two Phillips M2.0 × 3.0 screws (2) that secure the board.
Basic camera function test on page
Display assembly on page
30.
Preparation for disassembly on page
30).
Battery on page
Component replacement procedures
Spare part number
M93501-001
M98507-001
M98022-001
M98501-001
29).
44).
35
Advertisement
Table of Contents
