Hinge Assembly - HP Split 13 x 2 PC Maintenance And Service Manual

c. Remove the hard drive bracket (3) from the hard drive.
The hard drive bracket, hard drive connector cable, and screws are available in the Hard
Drive Hardware Kit, spare part number 736884-001.
Reverse this procedure to install the hard drive.

Hinge assembly

NOTE: The hinge assembly spare part kit includes two cables and two rubber feet.
Description
Hinge assembly (includes 2 cables and 2 rubber feet)
Before removing the hinge assembly, follow these steps:
1.
Turn off the tablet and keyboard base. If you are unsure whether the tablet and keyboard base are
off or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2. Disconnect the power from the tablet and keyboard base by unplugging the power cord from the
tablet and keyboard base.
3.
Disconnect the tablet from the keyboard base.
4.
Remove the bottom cover (see
5. Remove the keyboard base battery (see
6. Remove the audio /USB board (see
7. Remove the power connector board (see
Bottom cover on page 63).
Keyboard base battery on page
Audio/USB board on page
Power connector board on page
Spare part number
736885-001
65).
68).
69).
Removal and replacement procedures
73