Set Gvrp Port Settings - TRENDnet TEG-448WS User Manual

TRENDnet User's Guide

Set GVRP port settings

Bridge > GVRP > Port Settings
This section will allow you to select which ports will have GVRP enabled or will be
restricted from using GVRP.
1. Log into your switch management page (see
on page 7).
2. Click on Bridge, click on GVRP and click on Port Settings.
3. Review the settings for each port. Click Apply to save the settings.
•
Port - This parameter displays the ports on the switch.
• Dynamic Vlan Status - This parameter defines the GVRP status of the port.
From the Dynamic Vlan Status field, select one of the following choices from
the pull-down menu:
Ignore - This parameter indicates that the setting in the All row does
o
not apply to the Dynamic Vlan Status field. In other words, each port
is set individually.
Enable - The Dynamic Vlan is activated for the port row selected.
o
Disable - The Dynamic Vlan is de-active for the port row selected.
o
•
Restricted VLAN Registration - This parameter controls if the VLAN registration
on the port is restricted or not.
Ignore - This parameter indicates that the setting in the All row does
o
not apply to the Restricted VLAN Registration field. In other words,
each port is set individually.
Enable - The Restricted VLAN Registration is active for the port row
o
selected.
Disable - The Restricted VLAN Registration is de-active for the port
o
row selected.
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your switch management page"
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-448WS
40