Configure The Snmp Community Table - TRENDnet TEG-448WS User Manual

TRENDnet User's Guide
• Click Add. The new User Name and Group Name are displayed on the SNMP
User/Group page.
Modifying SNMP User and Group Names
If you need to modify an entry in the SNMP User/Group page, you must first delete the
entry and then re-enter it.
Deleting SNMP User and Group Names
In the Action column of the table, click Delete for the User Name and Group Name that
you want to remove.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2013 TRENDnet. All Rights Reserved.

Configure the SNMP Community Table

SNMP > Community Table
A community string has attributes for controlling who can use the string and what the
string will allow a network management station to do on the switch. The Web
Management Utility does not provide any default community strings. You must first
define an SNMP User and Group Name on the SNMP User/Group page and then define a
Community Name on the SNMP Community Table page.
1. Log into your switch management page (see
on page 7).
2. Click on SNMP and click on SNMP User/Group.
3. Review the settings.
Create SNMP Community Settings
•
Enter a new Community Name. A name can be up to 31 characters in length.
• Enter a User Name(View Policy) that has been previously defined. This name
must match one of the User Names displayed on the
Note: SNMP User/Group page. If you enter a user name that has not been pre-
defined on the SNMP User/Group page, the Community entry is displayed, but
the agent/manager communication fails.
•
Click Add. The values of the new Community Name and User Name are
displayed.
TEG-448WS
"Access your switch management page"
49