View Your Trunk Group Status Information; Configure Your Port Priority - TRENDnet TEG-448WS User Manual

TRENDnet User's Guide

View your trunk group status information

Bridge > Trunk Config > LACP Group Status
1. Log into your switch management page (see
on page 7).
2. Click on Bridge, click on Trunk Config, and click on LACP Group Status.
3. View your trunk group status information.
•
System Priority - Preassigned setting that cannot be modified. This value
applies to the switch.
• System ID - MAC address value assigned to the individual switch. This value
cannot be modified.
• Group: # The ID number of the trunk (link aggregation group).
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your switch management page"

Configure your port priority

Bridge > Trunk Config > Port Priority
1. Log into your switch management page (see
on page 7).
2. Click on Bridge, click on Trunk Config, and click on Port Priority.
3. Review the settings. Click Apply to save changes.
To assign a port higher priority within a trunk group, find the port number and in the
priority column, enter a priority value 0-65535 (65535 being the highest priority).
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-448WS
"Access your switch management page"
27