Access Control Config; Configure Policy Settings - TRENDnet TEG-448WS User Manual

TRENDnet User's Guide
Modify a Trap Host Table Entry
If you need to modify an SNMP Trap entry, you must first delete the entry by using the
procedure below and then re-enter it with the modification by creating a new SNMP
trap.
Delete a Trap Host Table Entry
To delete an entry in the host table, click Delete next to the entry in the table that you
want to remove. The Host table entry is removed from the table. No confirmation
message is displayed.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2013 TRENDnet. All Rights Reserved.

Access Control Config

Access Control configuration allows you to control different aspects of the Ethernet
traffic as it enters the switch ports and is process through the Switch. You can specify
what traffic is permitted or denied to flow through the switch by setting up specific filter
criteria at an ingress port. You can also manage the switching priority of Ethernet
packets. All of this is done by specifying policies that define the filtering and priority
behavior.

Configure Policy Settings

Access Control Config > Policy Settings
The Policy Settings page allows you to specify the filtering criteria for one policy. You
can create, modify or delete a Policy by following the procedures in the following
sections:
1. Log into your switch management page (see
on page 7).
2. Click on Access Control Config and click on Policy Settings.
3. Review the settings.
Choose the type of policy to create:
•
Add L2+IPv4
•
Add IPv6
Note: Please note that when adding polices, it is important to note that the rule/policy
order of priority in which the rules/policies are evaluated by the switch, 1 being the
highest priority.
TEG-448WS
"Access your switch management page"
51